Moulding Italian Acetate Sunglasses

Moulding and manipulating Italian acetate sunglasses to achieve the perfect fit requires careful attention to detail and a gentle touch. Here are some steps you can follow to mould and manipulate your Italian acetate sunglasses for the perfect fit:
NIKNCQ
STEP 1
Prepare the sunglasses: First, make sure that the sunglasses are clean and free from any dirt or debris.
You will also need a bowl of hot water and a towel.
KWINIKNCQ
STEP 2
Heat the frames: Hold the frames of the sunglasses over the bowl of hot water for
approximately 30 seconds.
This will soften the acetate and make it more pliable.

STEP 3
Bend the arms: Once the acetate has softened, gently bend the arms of the
sunglasses to adjust the fit.
Be sure to apply even pressure to both arms to avoid damaging the frame.

STEP 4
Adjust the nose pads: Use your fingers to adjust the nose pads to fit comfortably on the bridge of your nose.
Be gentle when doing this to avoid bending the frame or breaking the nose pads.

STEP 5
Cool the frames: Once you are happy with the fit of the sunglasses, hold them under cold running water or place them in a bowl of cold water to cool and set the frame.

STEP 6
Dry the frames: Once the frames have cooled, dry them off with a soft towel.

STEP 7
Repeat if necessary: If the fit is not perfect, you can repeat the process until you achieve the desired fit.

It is important to note that acetate sunglasses can be delicate, so it is important to handle them with care when moulding and manipulating them.
Be sure to apply even pressure and not to bend the frame too much as this can damage the material.